In most cases i apply heat with my heat gun to insure the seams bond well and roll each seam well with a heavy roller. I just used silicone to stick it to detached unheated pre-fab concrete garage wall. Install a decorative molding to finish the ceiling and cover the nails or screws along the walls. Before mounting a TV or other items, screw in a sheet of plywood on the wall first and then install the laminate planks on top of the plywood. With the odd nail in here and there to hold it while the glue took hold. The key is to experiment and measure out how much you'll need. Laminate flooring planks install with a tongue and groove system, so each plank has a tongued side and a grooved side. Nailing to the floor may cause the top of the quarter round to pull away from the wall over time. However, if you are not too keen on spending a lot of time doing this, it is also possible to place 1/8-inch hardboard sheets over the wall before attempting to lay the vinyl floor planks on to it. To insure your laminate flooring stays securely in place, you should secure the planks to the wall in the location of the studs. Also if you are installing laminate flooring, you do not want a nail through the laminate. You will have added support for the screws bearing the weight. The trick is to find the right size drill bit for the nail. When repairing irregularities, screw on a sheet of plywood (as thin as you can get) on the wall before installing laminate wood walls. The first thing to know when learning how to lay laminate flooring is that all laminate flooring will expand and contract due to temperature and humidity fluctuations. The solution is to angle-cut the lengths of the first and last courses for your laminate floor layout pattern, so the floor is straight even if the walls aren't. Yes nail to wall and research the seam cement that the company that makes the flooring may have. The best way to smooth your walls off before applying the vinyl plank flooring will be to sand them down. 10. Also, it is possible to nail in some areas, but do so using 6d or smaller nails, so they aren't too visibly seen. When installing the last row of planks, allow a 1/2-inch clearance from the end wall and secure the last row with face nails or screws like you did with the first row. I hand nail the rows that I can't use my manual Porta-Nailer floor nailer then drill holes in the tongue and hand nail them. I did this a while back in my garage with leftover laminate. To allow for this expansion, place 3/8-inch spacers along the wall to leave a consistent gap around the edges of the floor. When I hold the nail gun, I nail not in the center Too small and the nail will bend on you, too big and it will not hold. How to Use Wood Laminate for Wall Covering. The last 3 rows of floor boards I usually face nail them with the floor nailer. It can hinder the contraction and expansion of the laminate flooring. If the wall isn't straight and you start a full course of flooring against it, then the whole floor will look crooked. There are many fine alternatives to the common standard use of drywall or plaster as a wall covering for new construction, or for remodeling. Using a Stud Finder, locate and mark the location of each stud. And just like a flooring installation, buy the Allure Ultra planks first and have them in …